Single Distribution Switch (Single Port Channel Downlink) Redundant Distribution Switch (Port Channel Peer and Downlink) The hostname or device name you provided as part of Quick Setup The hostname or device name you provided as part of Quick Setup The hostname or device name you provided as part of Quick Setup Layer 3 settings configured on the management port, based on Quick Setup Layer 3 settings configured on the management port, based on Quick Setup Layer 3 settings configured on the management port, based on Quick Setup Selected uplink ports connect to other distribution or core switches Selected uplink ports connect to other distribution or core switches Selected uplink ports connect to other distribution or core switches Downlink connections to access switches configured in Trunk mode Downlink connections to access switches configured in Trunk modeDownlink connections to access switches configured in Trunk modeStandalone Collapsed Core Switch (with ECMP Peer and Port Channel Downlink) The hostname or device name you provided as part of Quick Setup The hostname or device name you provided as part of Quick Setup Layer 3 settings configured on the management port, based on Quick Setup Layer 3 settings configured on the management port, based on Quick Setup In the For more information on Cisco Catalyst 9800 series, please go to: The document does not cover details on how to bootstrap the ISE, C9800, and AP. In the You can create license pools (virtual accounts) to reflect your organization structure. Periodically, this information is exchanged to keep the databases synchronized. A USB device driver must be installed the first time a Microsoft Windows-based PC is connected to the USB console port on between the switch and your PC or terminal possible. It is supposed to auto-renew, however, this does not work, as it says Port 80 is blocked on our Firewall. Create dACL with following ACE on ISE and apply it to the redirect authorization profile below:This section describes additional configuration needed to configure the WLAN as FlexConnect Local switching and integrate it with ISE. Disconnect the switch console terminal before uninstalling the driver.Run setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. In the Look at the configuration guide and pre-requisites before enabling NBAR . see To register a device with the new token, perform this procedure:Registers the device with the back-end server using the token generated from CSSM.To verify the status of a license after registration, use the When your device is taken off the inventory, shipped elsewhere for redeployment, or returned to Cisco for replacement using CSSM enables you to manage all your Cisco smart software licenses from one centralized portal. (Optional) Exits ca-trustpoint configuration mode and returns to privileged EXEC mode. Is there a configuration guide to do so ? PDF - Complete Book (4.2 MB) PDF - This Chapter (1.73 MB) View with Adobe Reader on a variety of devices. ePub - Complete Book (444.0 KB) View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone The Web User Interface (Web UI) is an embedded GUI-based device-management tool that provides the ability to provision the To configure and enable the Call Home service through an HTTPs proxy, perform this procedure:Configures the default email address as sch-smart-licensing@cisco.com.Configures the proxy server information to the Call Home service.By default, the CiscoTAC-1 profile is inactive. For conditions that can cause a stack reelection or to manually elect the active switch, see the stacking software configuration guide Stack Manager and High Availability Configuration Guide for Cisco Catalyst 9200 Series Switches on Cisco.com.